Dräger Float Probe 8327654
$73.25
The Dräger Float Probe 8327654 for use with the Dräger X-am pump stops liquids from entering the sampling system by floating the sampling tube.
- Includes float probe
- Luer adapters
- FKM hose
Description
Dräger Float Probe 8327654 with Luer Adapter and FKM Hose will float on a liquid surface preventing water or other liquids from entering the sampling system. Works with many Draeger multi gas meters and pumps.
Draeger Hose FKM helps test for hazmat substances that can be measure in the ppb range, in hard to reach places like pipes, ducts, and tanks up to a distance of 147.6 feet (45 meters). With the Draeger multi-gas detection monitor also gives first responders precise results right on site. This replaces slow, expensive lab analyses. Hoses available in multiple lengths here >>
- Draeger FKM hose 8325705: inner diameter: 3.2 mm, length: 5 m (16.4 ft)
- Draeger FKM hose 8325706: inner diameter: 3.2 mm, length: 10 m (32.8 ft)
- Draeger FKM hose 8325707: inner diameter: 3.2 mm, length: 20 m (65.6 ft)
- Draeger FKM hose 8328212: inner diameter: 3.2 mm, length: 45 m (147.6 ft)
Need More Information?
For more information about the Draeger 8327654, Float probe, 5cm hose, other accessories, and gas detection devices, contact us today!
Draeger X-act 7000 Manual PDF |
Dräger sampling hoses for portable gas detection devices |
Dräger-Tubes and MicroTubes Product Safety Information |
Dräger sampling hoses for portable gas detection devices
Working in confined spaces and containers like pipelines, silos, ducts and shafts is part of everyday operations in many industries. But before maintenance, cleaning or repairs can take place inside these spaces, any risks facing the workers must be minimised. In general, a risk assessment will determine which specific risks might occur. Common risks include concentrations of toxic or explosive gases and fumes, as well as life-threatening oxygen depletion.
To prevent accidents and protect workers, these confined spaces and containers must be cleared for entry. That means checking and analysing the concentrations of any hazardous substances that may be present. This is done from outside by using sampling hoses that can be connected to compatible multi-gas detection devices. These hoses enable you to take in gas samples and test them remotely without exposing the testing crew to hazards.
TIME IS A RELEVANT FACTOR DURING TESTING
Before each test, the sampling hose must be flooded with the air sample to be tested. The flooding phase is intended to eliminate any interfering factors such as “dead volumes”. Flooding times vary depending on the type and concentration of gas or vapor being tested, as well as the material, length, diameter and age of the testing hose. As a rule of thumb, this approach is recommended: With a dry, brand-new hose, allow the hose to be flushed for about 3 seconds per meter. Use the 8327654 Draeger Float probe when liquids may be encountered during testing.
During the testing phase, The narrower the hose diameter, the faster the results will be available. For a volume flow of 0.3 l/min, a standard gas such as methane, oxygen or carbon monoxide only takes 1 about 5 seconds to pass through a 10 m hose with an inner diameter of 3 mm. Under the same conditions, it takes the same gas as long as 40 seconds to pass through a 10 m hose with an inner diameter of 5 mm – in other words, almost 3 times longer. The table below shows other testing times for hose lengths of 10 and 45 metres, at three different volume flows and an inner hose diameter of either 3 mm or 5 mm. In all these cases, the 3 mm hose works more than twice as fast as the 5 mm hose.
Dräger Float Probe, Transparent, 5cm Hose and 5mm Connector Drager 8327654
Additional information
Weight | 1 lbs |
---|---|
Dimensions | 4 × 4 × 2 in |
You may also like…
-
- Sale!
- Dräger X-act 7000, Dräger X-am 2500 & Accessories, Dräger X-am 2800 & Accessories, Dräger X-am 5000 & Accessories, Dräger X-am 5100 & Accessories, Dräger X-am 5600 & Accessories, Dräger X-am 5800 & Accessories, Field Testing and Detection
Dräger Mark II X-am Pump 8327115
- Original price was: $510.00.$459.00Current price is: $459.00.
- Add to cartAdd to quote
-
- Dräger X-am 2500 & Accessories, Dräger X-am 3500 & Accessories, Dräger X-am 5000 & Accessories, Dräger X-am 8000 & Accessories, Dräger X-dock & Accessories, Gas Detection
Draeger Sampling Hose Vitron Tubing
- $108.00 – $1,482.00
- Select options This product has multiple variants. The options may be chosen on the product page