Clor-N-Oil PCB Screening Kit, Dexsil
Portable and simple to use, the kit gives positive or negative colorimetric result to scale of 50 ppm. Kit includes disposable polyethylene pipet for obtaining sample, two test tubes with pre-measured test ampoules, and complete step-by-step instructions. Conducts one test only.
U.S. EPA SW-846 Method 9079
Designed to be used in the field, Clor-N-Oil is a fast, accurate method to test electrical insulating fluids for the presence of PCB. Each pocket-sized kit contains everything necessary to perform the test in less than 5 minutes. All premeasured reagents are sealed in glass ampules for safe, fast, consistent and accurate results. Screening transformer oil with Clor-N-Oil can eliminate non-PCB fluids from costly laboratory analysis and allows a greater number of samples to be tested at less cost.
Clor-N-Oil is available for testing transformer oil at three different action levels; 20 ppm, 50 ppm and 500 ppm. To eliminate the possibility of false negatives, Dexsil calibrates all Clor-N-Oil test kits on Aroclor 1242. Aroclor 1242 contains the least amount of chlorine (42% by weight) of the Aroclors found in electrical insulating fluids. By calibrating our test kits using Aroclor 1242, the user obtains the most conservative results. When Clor-N-Oil test kits turn purple, you can be assured your oil sample is below the action level.
The Clor-N-Oil kits are an appropriate method for testing DIELECTRIC FLUID (transformer oil) ONLY. They cannot be used to determine PCB contamination of other types of oils (i.e. used motor oil or other types of lubricants/industrial oils).
Note: Restricted. Cannot ship internationally.
- Analyzes: PCB
- Matrixes: Transformer Oil
- Detection Methods: Fixed endpoint colorimetric titration
- Action Levels: 20, 50, or 500 ppm
- Analysis Time: Less than five minutes
- Catalog Number: CL-000
|Dimensions||4 × 4 × 4 in|
Clor-N-Oil 20, Clor-N-Oil 50, Clor-N-Oil 500